Hey there all,
i am having a weird problem with the send mail task in SSIS. I have tried to different things, and i end up with two different errors:
Firstly, i have setup a data dump to excel, and the send mail taks emails this to specific email addresses.
In the Send mail task i have validated to SMTP server, and its correct.
I have manually entered all the information in the Send mail task, and i am sending to multiple email addresses. These are all seperated by a semi colan. I run the task and it fails on the send mail task with the follwoing error:
Error: 0xC002F304 at Send Mail Task, Send Mail Task: An error occurred with the following error message: "Unable to send to all recipients.".
Task failed: Send Mail Task
I have validated all the email address and they are correct. I did some searching and someone suggested to replace the semi colan with a comma. I do this and i get the follwoing error"
Error: 0xC002F304 at Send Mail Task, Send Mail Task: An error occurred with the following error message: "Mailbox unavailable. The server response was: 5.7.1 Unable to relay for rpwallis@bigpond.com.au".
I have checked that the IP for the SQL server is on the list of allowed relays on our exchange server. Does it make a difference if i am running this from Visual studio on my laptop?? by this, does it pick up the ip of my laptop when i test this or does it use the ip address of the server?? This would explain the relay message error if so..
Could someone please explain if i should use comma's or semi colans to seperate email addresses? and also lead me in the right direction in relatio to my problems..
Many thanks in advance
Scott Lancaster